TSM
TSM11 Quick Setup Guide
Requirements
You will need these items to set-up the TSM11:
• A 15 - 30 volt DC (24VDC nominal) power supply
• Download
Step-Servo Quick Tuner
software from Applied
Motion Products' website
• A PC running Windows XP, Vista, Windows 7 or Windows 8
(32-bit or 64-bit)
• A mating cable(for power, I/O and communication
connection, included in package)
• A RS-485 converter
Step1
Step2
Install the Software
Before utilizing the TSM11 Integrated Motor and
Step-Servo Quick Tuner
Software in an application, the following
steps are necessary:
a)
Install the
Step-Servo Quick Tuner
b)
Launch the software by clicking Start
Step-Servo Quick Tuner
software...Programs...Applied Motion Products.
c)
Connect the drive to the PC using RS-422/485, it is recommended to set up in a 4-Wire configuration
(see “communication” below.)
Connect the Power Supply
a)
Connect the power supply “+” terminal to the drive “+” terminal & the power
supply “-” terminal to the drive “-” terminal using AWG26 wire.
b)
Be careful not to reverse the wires. Reversing the connection may open
the internal fuse and void the warranty.
c)
If a regulated power supply is being used, there may be a problem with
regeneration that can be solved with the use of a Applied Motion Products
RC880 Regeneration Clamp. Please see the Applied Motion Products
website or the TSM11 User Manual for more information.
d)
Apply power to the drive.
e)
The software will recognize the drive and display the model and firmware
version.
To Power Supply-
To Power
To Earth Ground
Safety Instructions
• Only qualified personnel should assemble,
install, operate, or maintain this equipment.
• Read all available documentation before
assembly and operation.
• It is vital to ensure that all system components
are connected to earth ground.
• This product contains electrostatically
sensitive components that can be damaged
by incorrect handling.
Note: As with any integrated motor, the TSM11 must be mounted so as to provide maximum heat sinking and
airflow. Keep enough space around the Integrated Motor to allow for airflow.
920-0098 Rev A
