Installing Side Cleaning Brushes
1. Insert one brush into each holder by pushing it into the
groove and moving it to the end of groove until it fits
securely (H).
2. To remove, move brush to the center of each groove
and gently pull out.
Charging Battery
1. Make sure power switch is Off.
2. Insert the battery charger plug into the CHARGE socket
(J) and plug charger into an AC outlet. The power
indicator light flashes green.
Note: It takes between 8 to 12 hours for unit to charge.
Once unit is charged, power indicator light becomes
steady.
How to Use
Important:
•
Use the unit to clean tile, hardwood floors and low- to medium-pile carpets.
Do not use on deep or shag-pile carpets.
•
Monitor its operation the first time it cleans to make sure it does not get stuck on
uneven surfaces or under furniture. For safety, the unit will shut off automatically
after 10 seconds of inactivity. After the first use, there is no need to supervise
it unless it is operating near children or pets.
1. Empty dust bin before every use.
2. Place unit in the middle of an open area in the room.
3. Turn on power switch.
4. Press the room size selector to set the cleaning time (D). After about 2 seconds,
the unit starts cleaning automatically (A). You can also press the AUTO button on
the remote control (E) to start the unit.
Note: The Zoombot™ Smart Vacuum has a built-in cliff-avoidance sensor that
automatically detects nearby stairs and redirects unit to opposite direction.
5. When finished cleaning, the unit beeps and stops. If power indicator light is
flashing red, the battery is low. The unit keeps beeping until you turn it off or
battery runs out completely.
6. To stop the unit at any time:
•
Pick it up; after 3 minutes of inactivity, it shuts off.
•
Turn off power switch, or
•
Press the STOP button on the remote control.
7. If you want to continue operation, place the unit on the floor and press the AUTO
button on the remote control.
Using Dust Cloths
Important:
Use dust cloths for sweeping tile and hardwood floors only.
Installing Dust Cloths in Holder
1. Wrap cloth around the top of the holder.
2. Pull cloth tightly and insert the left and right
edges into each grip slot until it catches the cloth
securely in place (K).
3. To install the holder into the unit, insert the side
tabs into the unit slots (L).
Tip:
Insert holder with long side facing toward the
front of the unit.
Care and Cleaning
Your Zoombot™ Smart Vacuum requires little maintenance. However, always clean
the dust bin and dust filter after each use.
Cleaning Dust Bin
1. Turn off unit.
2. Press the push button right in front of the dust bin
cover to release bin.
3. Grip dust bin and pull out (M).
4. Pull off cover.
5. Grasp dust filter tabs and pull it out (N). Empty dust
bin and wash with sudsy water.
6. Clean dust filter with a used toothbrush or small soft
bristle brush. After 3 to 6 months of use, you should
replace filter with a new one. To order replacement
filters, call 1-800-738-0245, Fox International, parts
and accessories.
7. Insert dust bin and filter in place.
8. Insert dust bin cover in the slots and press until it snaps into place.
Cleaning Vacuum Intake and Side Cleaning Brushes
Clean periodically as dust and hair can accumulate, which can slow down the
cleaning performance.
1. Turn off unit.
2. Shake any dust off and remove any accumulated hair.
K
L
M
N
H
J
RV500.Pub1000001402 9/8/04 4:15 PM Page 8