600840-000041 Stratus Power Installation Instructions
Rev. 1.0
Last Revised: December 15, 2016
Page 7 of 12
2. Mounting Stratus Power
NOTE:
Stratus Power is only compatible with a panel thickness of .040” to .125”.
1. Disconnect aircraft power.
2. Locate an area in the panel to mount Stratus Power. The location must provide
adequate clearance in the front and back of the unit based on the dimensions given in
Table 3.
ATTENTION:
Process may result in metal shavings. Ensure that they do not fall behind
the aircraft panel.
3. Drill out a circle in the mounting location with a 1 ¼ inch drill bit using the measurements
in Figure 1. Then, cut the notch in the top of the hole.
Figure 1: Mounting location
4. Place the Stratus Power unit behind the panel and align the front of the unit with the
hole. Place the panel cover over the front of the unit and secure with screws.
