2
FILAMENT REQUIREMENTS
Do not abuse the filament. Please make sure you use the Apollo3D filament or the filament from
the brands accepted by Apollo3D.
FILAMENT STORAGE
All polymers degrade with time. Do not unpack until filament is needed. Filament should be
stored at clean and dry conditions.
LEGAL NOTICE
All the information in this document is subject to any amendment or change without the official
authorization from Apollo3D.
APOLLO3D CORPORATION MAKES NO WARRANTY OF ANY KIND WITH REGARD
TO THIS DOCUMENT, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED
WARRATIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
Apollo3D shall not be liable for errors contained herein for incidental consequential damages in
connection with furnishing, performance or use of this material.
Apollo3D reserves the right to modify the User guide due to subsequent equipment updates.
Copyright © 2020 Apollo3D Corp. All Rights Reserved
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant · to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for help.
This document contains proprietary information protected by copyright.
SERVICE
Always unplug Saturn from its power before performing any service procedures. Failure to do so may
result in personal injury and equipment damage.
Use only Apollo3D approved materials and components. Use of object materials, or 3D objects other
than Apollo3D approved object materials and genuine Apollo3D components may void warranty.
