1. Push the Needle (
#22
) back into the spray gun.
2.
I
nsert the Needle Spring into the Material Adjustment Screw (
#20
).
3. Install the Material Adjustment Screw with Needle Spring (
#21
).
4. Install air cap and air cap ring. Spray gun is now re-assembled and ready to use.
5. Remove the Material Blanking Cap (
#12
) from either the gravity or bottom feed port of the spray gun and clean out any material.
NOTE:
When reassembling your spray gun, do not tighten down the Air Cap Ring
(#1
), leave it loose. This will ensure that if there is any
material residue on the threads it will not dry and seal itself to the Air Distributor (
#7
).
NOTE:
Periodically, use Apollo spray gun lube to lubricate the Air Valve Bushing as shown.
For Genuine Apollo replacement parts and accessories visit our web site and on-line catalog at HVLP.com
7
8-9
10
11
1
2
3
4
5
6
