4. Remove the Fan Adjustment Ring (
#9
) and Air Distributor Plate (
#8
). The Air Distributor Plate is attached to the ring. These two pieces separate.
5. Clean them both if necessary.
NOTE:
Make sure you reassemble the two pieces correctly or you will only get a round fan pattern.
6. Remove the fan adjustment seal (
#10
). Clean if necessary.
RE-ASSEMBLE THE SPRAY GUN
1. Insert the Fan Adjustment Seal
(#10
)
2. Insert the Fan Adjustment Ring and Air Distributor Plate. (
#8 and #9
). If you have separated these two pieces it is critical that the white air
distributor plate is correctly re-inserted into the Fan adjustment ring. Note that the open slots on the Air Distributor Plate must be visible
through the holes of the Fan Adjustment Ring at the 12 o’clock and 6 o’clock positions.
3. Using the back end of the Needle, move the Air Distributor Plate so that the round hole is at the 5 o’clock position. DO NOT put the Air
Distributor Plate and Fan Adjustment Ring together as show in the picture marked “incorrect”. You will only be able to achieve a round
spray pattern.
4. Place the Air Distributor onto the body of the spray gun aligning the pin with the hole in the spray gun body at the 5 o’clock position.
5. Screw the Nozzle (
#4
) back onto the spray gun, finger tight. Rotate the Fan Adjustment Ring to be sure it rotates freely and easily. Tighten
6. the Nozzle slightly more with the wrench (spanner). Rotate fan adjustment ring again. Do not over tighten the fluid nozzle as it will stop the
Fan Adjustment Ring from rotating easily. If too tight, back it off slightly. Be sure that the Nozzle is not too loose or leaking will occur.
7. Insert the Air Cap Seal (
#5
). To insert, observe both sides of the seal. One side should have three small circles. This side goes toward the
spray gun. Snap the Air Cap Seal onto the Air Distributor (
#7
).
1
2
3
4
5
