Apollo Sprayers MAXI-MISER PBC7600-GTO, Инструкция по эксплуатации

Страница: 5 / 20

4
5. Setup
5.1 Installing Air Relief Mechanism (Turbine Systems Only)
As previously noted, Apollo Models 725, 825, 835, 835VR, 1025, 1035,
1040VR,1050, 1050VR, Falcon Series, Power Series and Precision Series have
an air relief mechanism internally installed and
DO NOT require an external air
relief mechanism. All other Apollo Models require the installation of Apollo
Part # A7538A to the turbine air outlet prior to operating the 7600 spray gun
The air relief mechanism Part #A7538A must also be installed on ANY MAKE
turbine system that does not have an air relief mechanism installed. If using with
a system other than Apollo, please check with the manufacturer to determine if
a non-bleed spray gun can be safely operated on your system. If not, install
Part
#A7538A before operating the 7600 spray gun.
5.2 Mounting Your PBC7600-GTO Spray Gun Cup
Good quality results with your spray finishing equipment are a combination of careful
preparation of your surface, a proper spraying environment and a basic knowledge of the
coatings you will be using and how these coatings work with your finishing equipment.
Your PBC7600-GTO spray gun comes with one of 4 sizes gravity feed cup assemblies,
90cc, 250cc, 600cc or 1000cc. Some minor assembly is required:
1. Screw the cup to the material connector on the top of the spray gun body.
2. Remove the screw in the side of the spray
gun body using the wrench (spanner) provided.
3. Screw the air feed connector onto the side of the spray gun body.
4. Push the air feed tube onto the air feed connector.