Apogee Mini-CONDOR, Руководство пользователя

Страница: 5 / 8

Page 5
18. Attach the launch lug to the side of
the tube using CyA adhesive in the approxi -
mate middle of the length of the pylon as
shown.
19. OPTIONAL: Glue the green engine
block into the tube using wood glue, 1-1/4
inch (3.2cm) from the end as shown. To
save weight, you can leave out this piece.
20. Using CyA adhesive, attach the
shoulder piece into the nose cone. Give it
a twist when inserted to even out the glue.
Wipe off any excess glue that oozes out with
a paper towel, and allow the adhesive time
to harden.
21. Cut out the shock cord anchor from
the front of instruction sheet. Spread wood
glue on one side. Take one end of the yellow
shock cord and lay it diagonally across the
paper. Fold it twice on the marked lines, and
then curl it slightly so it will fit into the tube.
Allow the glue time to set up so it doesn’t
unfold.
22. Glue the shock cord mount into the
front of the tube using wood glue. Make sure
it is deep enough to allow the shoulder of
the nose cone to be inserted into the tube.
23. Tie the free end of the yellow shock
cord to the loop on the base of the nose
cone. Put a drop of wood glue on the knot to
keep the cord from coming untied.
18
20
21
22
23
19
1-1/4” (3.2 cm)
Approximately 1-1/4” (3.2 cm)