APOGEE ELECTRONICS
1
Maestro
– User’s Guide
Introduction
Apogee’s Maestro software application provides control, routing and low-latency mixing functionality for Apogee
hardware interfaces connected to an Apple Macintosh computer. Maestro gives you control of your Apogee
system by allowing you to adjust hardware settings, configure routing between hardware and software I/O, and
create low-latency mixes of hardware I/O paths and software outputs.
As of Maestro version 1.3, the following Apogee hardware interfaces are supported:
• Duet Firewire Interface
• Ensemble Firewire Interface
• Symphony PCI card(s) with AD16X,DA16X, Rosetta 800 or Rosetta 200 connected
• Symphony Mobile Express/34 card with AD16X,DA16X, Rosetta 800 or Rosetta 200 connected
• MiniFW card for Apogee MiniMe and MiniDAC interfaces
Computer requirements:
• OSX 10.4.10 or above
• Apple Macintosh PowerPC or Intel CPU, 1.0GHz or higher, 1GB of RAM required, 2GB recommended
• Supported Apogee hardware and all necessary drivers and OS X updates must be installed, tested and
operating correctly
Installation:
To install Maestro, unzip the file (if downloaded) or insert the CD that accompanies Apogee hardware, and
follow the on-screen instructions provided by the installer.
