Aplex VIPAC-915 G(H), Руководство пользователя

Страница: 22 / 83

VIPAC-9XX Series User Manual
21
2.4 Jumpers Setting and Connectors
1. SW1-2:
CMOS clear switch, CMOS clear operation will permanently reset old BIOS settings
to factory defaults.
SW1 CMOS
Pin2 OFF NORMAL (Default)
Pin2 ON Clear CMOS
Procedures of CMOS clear:
a) Turn off the system and unplug the power cord from the power outlet.
b) To clear the CMOS settings, use the switch to Pin2 on for about 3 seconds then
move
the switch Pin2 off.
c) Power on the system again.
d) When entering the POST screen, press the <DEL> key to enter CMOS Setup
Utility to load optimal defaults.
e) After the above operations, save changes and exit BIOS Setup.
2. BAT1 :
(1.25mm Pitch 1x2 wafer Pin Header) 3.0V Li battery is embedded to provide
power for CMOS.
Pin# Signal Name
Pin1 Ground
Pin2 VCC_RTC
3. SW1-1:
Switch, DC Power input setting,Power on/off button and Auto Power on switch
setting .
SW1 Function
（
DC input /DC_IN1
）
Pin1 ON Auto Power on (Default)
Pin1 OFF Power on/Off button (option)
4. BT1:
(2.0mm Pitch 1x2 Wafer Pin Header), Power on/off , They are used to connect
power switch button. The two pins are disconnected under normal condition. You may
short them temporarily to realize system startup & shutdown or awaken the system
from
sleep state.
5. DC_IN1:
(5.08mm Pitch 1x3 Pin Connector),DC9V ~ DC36V System power input connector
。