Static Processor
5
DESCRIPTION OF CONTROLS
FRONT PANEL
1.
Sub level
: This potentiometer controls the level of the sub-woofer. A center detent indicates the
nominal position. The range is from infinite attenuation to 6dB gain.
2.
With Sub/No Sub
: When engaged this switch inserts a High Pass Filter in the signal path,
providing the necessary cross-over function needed when sub-woofer are used.
Note
: The sub output is always active. It is not recommended to use a system with sub-woofer
and the switch disengaged, because of energy cancellation due to improper phase response.
3.
Power Led:
indicates presence of mains voltage.
The SPMICRO can be operated continuously; thus it does not have a mains switch.
REAR PANEL
The SPMICRO has two inputs and 3 outputs, all electronically balanced; the connectors are 3 pin XLR's.
The mains receptacle is at the EEC standard with the center prong connected to the ground.
For obvious safety reasons it should always connected.
The SPMICRO uses a hum loop eliminator.
If any hum or buzz occurs, it is not caused by a ground loop.
The mains fuse must be replaced only with the same type and value.
220 – 240 Vac 0.1 A Temp
100 – 125 Vac
0.2 A Slow-blow
