9
Allison Park Group Inc.
• 4055 Alpha Drive
• Allison Park, PA
15101
•
www.apgvision.com
Telephone (412) 487-8211
• Fax (412) 486
-3157
• E
-Mail: [email protected]
Cleaning and Maintenance
Stainless Steel:
When cleaning the stainless-steel body of your enclosure be sure to avoid bleach and cleaners with
chlorine as these will stain and damage the surface. Additionally, steel wool and brushes should be
avoided to preserve the polished finish.
Aluminum:
Anodized aluminum parts may require abrasive cleaning with gentle cleaning products such as soap and
water. Harsh cleaning products may react with unfinished aluminum parts.
Acrylic / Polycarbonate:
Although your acrylic window comes with an anti-abrasion coating, it is important to routinely clean the
surface to maintain visibility. APG recommends a plastic/acrylic cleaning solution, otherwise use soap and
water with a microfiber towel.
DO NOT use ammonia, acetone, or alcohol-based cleaners; this will crack and weaken the acrylic.
Glass:
It is
important to routinely clean the surface of your enclosure’s window to maintain visibility. For glass,
make sure the surface is wet before cleaning to avoid scratching the surface. A microfiber towel is
recommended for wiping down the surface when you are finished washing.
Temperature Tolerance
The listed temperature ranges are for reference only. Exceeding these values may result in compromising
the liquid tight enclosure and permanently damaging the material. Stainless Steel and Nickel-plated Brass
Cable Gland Bodies are available if your application exceeds these materials’ tolerances.
Polyethylene: -4° to 200° F
EPDM Foam:
-40° to 250° F
Polycarbonate: -4° to 285° F
TPE Split Insert: -20° to 285° F
Viton™
Rubber: -20° to 400° F
Silicone:
-100° to 400° F
