6
Allison Park Group Inc.
• 4055 Alpha Drive
• Allison Park, PA
15101
•
www.apgvision.com
Telephone (412) 487-8211
• Fax (412) 486
-3157
• E
-Mail: [email protected]
4.
Installing your component(s) into the enclosure:
a.
It may be
helpful to run your device’s cable(s) into the enclosure through the Cord Grip
before mounting the device into the enclosure.
b.
Align the mounting holes on your device with the hole cutouts on the enclosure Mounting
Arm.
c.
Secure your device to the Mounting Arm using the fasteners provided with your device or the
optional bolts included with the enclosure.
Note: If the Mounting Arm for your enclosure has slot cutouts, use these to position the lens
of your camera or sensor as close to the Viewport as possible to avoid reflections.
5.
Refer to the Cable Gland Instructions at the end of this manual for proper milling of Cable Gland
Insert and cable(s) installation.
6.
Sealing the enclosure:
a.
With your component(s) installed in the enclosure, reinstall the barrel that you removed in
Step 2.
b.
Hand tightening the Faceplate, Barrel, and Enclosure Body together will be enough to seal
your enclosure and meet its IP rating. Threads will be pre-lubricated to keep the seal.
