6
■
Installation (cont.)
４
.Cut the pressure signal wire or VTEC solenoid signal wire of the vehicle harness
connected to the ECU and install a plug by referring to the Wiring Diagram by Model.
For some applicable models, cut the VTM signal wire and install a plug.
５
.Connect the harness attached to the V-AFC II to the plug installed in 4.
６
.Make sure to insulate the unused wires and plugs with a vinyl tape.
※
Poor insulation may result in short-circuit, which leads to a danger.
７
.Connect the negative (-) terminal of the battery.
●
Be sure to connect the black wire and the brown wire of the
harness attached to the VAFC II to the ground conductor.
This product may not function normally, thereby giving damage to the product and the
engine.
●
When locating each wire, take special care not to cause a
short circuit.
A fire may be caused or electric devices may be damaged.
●
Install the splice for branching securely without any contact
defect.
A fire may be caused or electric devices may be damaged.
VTEC solenoid signal
Plug receptacle: Pressure sensor side
Plug: ECU side
Plug receptacle: ECU side
Plug: VTEC solenoid side
Pressure sensor signal
VTM signal
Plug receptacle: ECU side
Plug receptacle: White wire
Plug: Yellow wire
Plug receptacle: Purple wire
Plug: Pink wire
Plug receptacle: Blue wire
CAUTION
！
VTEC solenoid signal
Pressure sensor signal
VTM signal
