Apex Digital EZ Sander EZ3760M, Руководство по эксплуатации

Страница: 20 / 71

20
4. If the conveyor belt is moving to the right
side, turn the right screw clockwise. This will
return the tracking toward the left. Conveyor
generally run to the loose side.
5. If the conveyor belt is moving to the left
side, turn the left screw clockwise. This will
return the tracking toward the right.
6. A positioning wheel (Figure 13) has been
provided on the right and left sides of the
conveyor belt to limit the belt tracking. When
adjusting the tracking, the conveyor belt
should be moved until its edge just touches
the positioning wheels.
7. Allow the sander to run for several minutes
while observing the conveyor belt tracking
and readjust if necessary.
Feed Rate
The feed rate is infinitely variable within the
provided range, in order to meet the sanding
requirements of a wide variety of materials.
Selecting a proper feed rate is largely a matter
of experience. In general, soft woods require a
higher feed rate, while hard woods require a
lower feed rate.
Change the feed rate while the conveyor belt is running.
Adjust the feed rate with the conveyor speed
adjustment knob on the control panel. Turn the
adjustment knob clockwise to increase the
conveyor belt speed, or counterclockwise to
decrease it.
Pressure Roll Adjustment
The front and rear pressure rolls have
been factory adjusted. This setting should,
however, be checked before operating the
sander.
The pressure rolls should be parallel to the
conveyor table with equal pressure on each end,
and are set slightly below the level of the
sanding belt. (.040 / 1 mm below contact drum)
Positioning wheel
Figure 13