The AIC400 is a fully programable Annunciator. Most of the parameter are configurable via ALCON
that is an advanced configuration software. It allows the user to create, edit, and send the required
configurations to the AIC400 Annunciators via USB port.
This allows the user to save the configuration on a PC as a backup. The configuration can be loaded
to the Annunciator at a later date.
ALCON is a very user friendly executable software with no installation needed.
Minimum system requirements:
IBM Compatible PC (min. 1GHz)
At least 1GB of ram memory
At least 100MB hard drive
1024x768 XGA or higher resolution
Windows 7 or higher Operating System
You need to install the USB driver on your computer first.
DO NOT connect the USB cable before driver installation is completed
Parameters programing by ALCON software
The following Annunciator parameters are configurable through the ALCON software.
1 - Logic Sequence of each Input
2 - Type of each Input: NO (Normally Open) or NC (Normally Closed)
3 - Assigning an Alarm Group to each Input (Critical or Non-critical)
4 - Auxiliary Relay function of each Input; “Input Follower (Repeat Relay)” or “Output Follower”
5 - Common Relays’ function (Relays 1 to 4):
System has four common relays. Each relay can be assigned to one of the following functions:
- Off
- System Ready Alarm
- Group 1 Horn
- Group 2 Horn
- Group 1 Common Alarm
- Group 2 Common Alarm
- All Groups Common Alarm
- First-up
- Ringback
- Power Supply 1 Alarm
- Power Supply 2 Alarm
- Redundant Power Supply Alarm
6 - System Response Time
7 - LEDs’ brightness
8 - Built-in Buzzer volume (sound level)
9 - “Auto Mute” On/Off. The Auto Mute timer is adjustable
AIC400 Series Alarm Annunciator
(15)
