4
1.
Automatic recording
Shooting starts when the vehicle's engine is turned on (power is turned on). At the
same time, the microphone lamp and the power lamp light up, and the REC lamp
starts blinking. Shooting ends when the engine is turned off (power is turned off).
The unit automatically saves the video and then turns off. When the memory of the
TF card becomes saturated, delete the oldest video and record.
•
audio is recorded during shooting (initial setting)
•
recording time for loop recording is adjustable between 1 min, 3 mins or 5
mins. Default setting is 3 minutes.
2.
Manual recording
Press the power button to start the unit. At the same time, recording starts
automatically. Press and hold the power button for 5 seconds, the unit will
automatically turn off after saving the video.
In standby mode, press the MIC button to enter video mode.
3.
After changing to the video mode on the upper left side of the screen, press the
OK button,
A picture is taken. Press the MIC button and press the OK button for 5
seconds
and y
ou will return to video mode.
4.
Motion detection
Press the MENU button in the standby mode to display the setting screen. Press the
MIC button, select the movement vernier <Move Detection>, and set its status to
“On”. Press the REC button to enter the movement detection mode. If the lens
detects a foreign object moving, the unit will automatically enter video mode. If
everything has not changed before the lens within 60 seconds, the recording will
stop. Enter the setting screen, set the status to "OFF", and exit the movement
detection mode.
[Caution] Do not use motion detection in running shooting mode.
5.
Gravity sensor
This device has a built-in gravity sensor. The device will automatically lock this video
if an accident occurs. A lock icon appears in the center of the screen.
[Note] The gravity sensor can adjust the sensitivity. By default, sensitivity is off. You
can change the sensitivity on the setting screen.
Basic operation and menu settings
