Apelson AMFTC72SS, Руководство пользователя

Страница: 16 / 24

16
INSTALLATION
AMFTC72SS
INSTALLATION METHOD 2
Remove the both upper shelf (A) and cross member
support (B) on the oven housing unit as shown. Cut the
bottom panel (C) of the oven housing as shown.
If required use support rails provided and screw onto side
of cabinet as shown in using 8x screws [Ø4mm x 10mm]
provided
Connect to mains power supply ensuring the cable is not
bent (see electrical connection)
Place the oven on the metal support rails by lifting the
appliance with the handles located on the side of the oven
and slide into place.
Secure the oven in place (see Page 14)
ELECTRICAL CONNECTION
All installation work must be carried out by a competent
Before connecting the mains supply ensure that the mains
voltage corresponds to the voltage on the rating plate
inside the cooker hood.
WARNING:
THIS APPLIANCE MUST BE EARTHED.
Mains Supply could be connected to the Mains Voltage by
Direct Connection
WARNING
Make sure the fused spur outlet is
located in an accessible position.
DIRECT CONNECTION
If the appliance is being connected
directly to the mains an omnipolar
circuit-breaker must be installed with a minimum opening
of 3mm between contacts.
If the cable is damaged or to be replaced, the operation
dedicated tools to avoid any accidents.
The installer must ensure that the correct electrical
connection has been made and that it complies with wiring
diagram.
The cable must not be bent or compressed.
The cable must be checked regularly and replaced by
authorized technicians only.
ELECTRICAL REQUIREMENTS
Any permanent electrical installation must comply with
the latest I.E.E. Regulations and local electricity company
contractor who is on the roll of the National Inspection
Council for Electrical Installation Contracting (NICEIC)
should undertake the electrical installation.
Electrical Connection
Before connecting the mains supply ensure that the mains
voltage corresponds to the voltage on the rating plate
inside the appliance.
WARNING:
THIS APPLIANCE MUST BE EARTHED
The appliance is supplied with a 3-core mains cable and
must be connected to the electricity supply via a double
pole switch having a 3mm minimum contact gap on each
connector.
50
50
A
B
C
04
560
21
547
718
594
600
570 min
720 min
30
7
41
Support rail
FUSE
USE A 32 AMP FUSE
DOUBLE POLE SWITCHED
FUSED SPUR OUTLET
ON