background image

APCO

    

 388 Grant Street, SE, Atlanta, Georgia USA 30312-2227      Telephone (404) 688-9000      www.apcosigns.com 

      

IS309 

APCO

    

 388 Grant Street, SE, Atlanta, Georgia USA 30312-2227      Telephone (404) 688-9000      www.apcosigns.com 

      

IS309 

06/28/01

Visuline

®

 2300 Series 

 

Non-Illuminated Display System

Preparing to Install

06/28/01

Visuline

®

 2300 Series 

 

Non-Illuminated Display System

Reassembly

Surface mounted modules utilizing the standard 2-3/4” thick 

Visuline cabinet (2300.3 Series), do not require preparation and 

are ready for installation.

For surface mounted modules utilizing the 3-1/2” deep LP 

cabinet (2300.3LP Series), proceed with the following 

instructions.

Open Door

To access the internal mounting structure, the door must first 

be opened. Units with optional door locks will have specific 

instructions applied to door face.

Dual Lock

 is an aggressive snap-locking device used with all 

door shapes. The door must be grasped at two positions as 

near as possible to the corners opposite the hinge side. (Refer 

to labels applied to door face.)

  IMPORTANT: DO NOT attempt to open door by pulling only 

one corner as this could cause glass breakage or other door 

damage.

APCO Concealed Lock Option

 is a spring-loaded locking device 

hidden beneath the door frame. A special Concealed Lock Key 

is used to unlatch the door. (Refer to labels on door.)

Conventional Keyed Lock Option

 is either a plunger or camlock 

device which uses a common-type key. (Refer to labels on 

door.)

Side Hinged Doors:

Side hinged doors do not require door supports and must be 

held open while unit is laying flat. Exercise care not to "spring" 

the door by allowing it to open beyond 90 degrees.

Top Hinged Doors:

Smaller top hinged doors are equipped with support rods which 

pivot away from the cabinet to mate with a notch provided on 

backside of door frame. Care must be taken not to dislodge the 

rod(s) when door is open.

Larger and Heavier top hinged doors are equipped with gas 

cylinder “assists”. Keyed locks assure door remains closed. See 

Figure 3.

  CAUTION: When cabinet is equipped with gas cylinder 

“assists”, maintain pressure against door and use extreme 

care when opening. (See labels on door.)

Reassembly

1.

  Re-insert display panel/insert(s).

Before closing door, ensure the following;

Side Hinged Doors:

 

- Exercise care not to "spring" the hinge by allowing the 

door to swing open beyond 90 degrees.

 

- DO NOT exert downward pressure on an open door.

Top Hinged Doors: 

 

- Ensure safety ribbons are secured to backside of door 

frame.

 

- Disengage and relocate prop-rods if applicable.

 

- For doors with gas cylinder “assists”, apply even 

pressure to both ends while closing. DO NOT close by 

pushing on any one corner as this may distort the glass 

and possibly cause glass breakage.

2.

  Close and press door frame firmly. There should be an 

audible “click” as a result of the Dual Lock fasteners 

being engaged. If door fails to function properly, refer to 

Trouble Shooting Guide in this section.

3.

  Remove remaining protective wrappings. 

4.

  Forward printed Maintenance Instructions to facility 

manager. For top hinged units, store padded corner 

guards and safety pylons for future servicing.

Lift Door & 

Disengage 

Prop-Rods 

Secure Safety 

Ribbons

Close Door & 

Listen For 

Audible “Click”

Secure Safety 

Ribbons

Close Door & 

Listen For 

Audible “Click”

NEVER LEAVE DOOR OPEN 

WHILE UNATTENDED !

Do Not Exert 

Downward Pressure 

on Open Door

Side Hinged Doors

Top Hinged Doors

Prop-Rod Door Support

Top Hinged Doors

Gas Cylinder Door Support

Smaller Top Hinged Doors

2

Position

Prop Rod

1

Lift

Door

Larger and Heavier Top Hinged Doors

2

Unlock

Door

1

Maintain

Downward

Pressure

3

Control

Opening

Pressure

Grasp & Pull

Door Here

To Open

Grasp & Pull

Door Here

To Open

Directory

Latch

• Insert Special APCO Key into 

  reveal behind door frame and

  slide spring-loaded latch 

  approx. 1/4"

• While latch is disengaged, lift

  door open.

UNLOCK HERE

Glass

1/98

LB308

To Disengage Lock, insert key 

into Lock and rotate clockwise, 

1/4 turn. Plunger sticks out when 

unlocked. 

Do Not force key past 1/4 turn.

To Lock, push plunger all the 

way in.

Directory

Lock

UNLOCK HERE

LB309

Door is Unlocked 

When Plunger 

Comes Out

Glass

1/98

Conventional Keyed Lock Operation

Concealed Lock Operation

Open Door From Two Points

Содержание Visuline 2300 Series













Отзывы: