APB DynaSonics
32
© 2006 APB DynaSonics – All Rights Reserved
Pre-Fader Switch (for Left/Right/Center/Mono)
This switch is common for both the headphone and monitor sources and determines if the Left, Right,
Center and Mono signals are derived pre or post (House Master) fader. The Aux 9 and Aux 10 signals are
always monitored post (Aux) fader.
Monitor Source Switches
(all selected sources mix together)
L-R:
When selected, this switch will route the L&R Outputs to the left and right monitor outputs.
C (enter):
When this switch is selected, it will route the Center Output to the center output of the monitor system.
When the Monitor System is set for 2-Speakers, a ‘phantom center” is created by feeding the Center
Output equally to both the L&R outputs of the Monitor system.
M(ono):
When this switch is selected, it will route the Mono Output to the center output of the monitor system.
When the Monitor System is set for 2-Speakers, a ‘phantom center” is created by feeding the Mono Output
equally to both the L&R outputs of the Monitor system.
External Monitor Input Switch:
When this switch is selected, it will route the External Line input to the monitors from the rear panel left
and right external input connectors.
Aux 9-10 Switch:
When this switch is selected, it will route a post level control Aux 9 (left) and Aux 10 (right) stereo signal to
the monitors. This allows for monitoring of this set of auxiliary outputs as a default signal without using
the solo system. This is useful when Aux 9-10 are being used to generate a separate record output.
Solo Off To Monitors Switch With LED
A solo signal will normally override any default signal source. When this switch is depressed, it will prevent
the solo signal from overriding the selected default Monitor signal. An LED will illuminate when this Solo Off
switch is activated. This switch can be used if a dedicated output is desired: Select the desired signals to mix
together (press their source switches to mix together), adjust the level. With the Solo Off switch depressed,
the Monitor outputs will NOT be interupted by the solo system.
Monitor (Speaker) Level Control
This control adjusts the stereo or LCR level being fed to the console monitor system. All 4 monitor outputs
are affected by this control (L, R, C, Sum)
Solo AFL Mode Center Yes-No Switch (Located In Solo Control Section)
Left-Center-Right post fader input signal is automatically routed to the master section for monitoring when a
channel is solo’d in AFL mode. IF the center signal is being used for other than a center channel, it may be
desirable for it NOT to appear as part of the solo’d signal that is being listed to. This switch will turn OFF the
center speaker feed to the monitor and headphone systems. The channels solo’d center signal will always
appear on the center solo meter regardless of the position of this switch.
Rear Panel Monitor Output Connectors
Impedance Balanced 1/4” output connectors are provided for Left, Center, and Right monitor outputs. An
additional 1/4” Impedance Balanced output connector is provided which is a sum of the Left, Center, and
Right signals. This connector may be used as a summed mono output to feed a sub-woofer system or to
drive a mono wedge monitor system when the console is used as a monitor console.
