11
After you have applied and worked in the care product, it must be removed and the paintwork must be polished.
Depending on manufacturer/type, the applied polishing agent must be completely dry. Now completely remove
the care product by polishing the paintwork with the terrycloth hood in the same order in which you applied the
polish. Set the appropriate revolutions for your care product.
6.3.3 Polishing the paintwork
Set the revolutions back to the lowest level every time you switch the device off. This prevents accidents
when switching back on again.
Element 1.pdf 1 25.01.19 10:55
7. Maintenance and care
Clean the polishing machine after each use. Pay particular attention to ensure the ventilations slots are clean. To
do this, use a dry, soft cloth. Do not use aggressive cleaning agents or solvents. Never allow liquids to get into the
device. You can use compressed air at a low-pressure to blow-out the device.
The polishing hood can be washed by hand in warm water. Leave the polishing hood to air dry.
Store the polishing machine without the hood. Position the polishing machine in such a way that the polishing
plate is not distorted. Do not place other objects on the polishing plate.
The carbon brushes may only be replaced after the guarantee has expired and this may only be carried out
by a specialist electrical company.
Element 1.pdf 1 25.01.19 10:55
8. Notes regarding environmental protection
9. Optionally available accessories
10. Contact information
Do not dispose of electrical devices with the household waste! Electrical and electronic scrap must be
collected separately and disposed of in an environmentally responsible manner for recycling. Please
contact your community or city administration regarding disposal options for electrical and electronic
scrap.
20980
Polishing hoods, towelling, diameter 180 mm
20981
Polishing hoods, wool, diameter 180 mm
20994
Polishing pads, diameter 180 mm
20997
Polishing sponge, soft, thickness 50 mm, diameter 180 mm
To release this button, press only the ON/OFF switch once briefly.
Pass the device evenly over the paintwork. Do not put pressure on the device. The work is carried out by the rotation
process, not the pressure on the paintwork.
First treat the large, flat surfaces such as bonnet, root and boot lid. Then move on to smaller areas, such as doors
and wings. For areas that cannot be reached using the polishing machine, remove the polishing hood and polish
by hand.
EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
[email protected]
www.eal-vertrieb.com
Содержание 20998
Страница 27: ...27 ...
