AP Expert VT-110, Руководство пользователя

Страница: 53 / 84

14
Outputs
Topics Covered in this Chapter
▪ Enabling the Misting Output
▪ Enabling the Soaking Output
▪ Heating Stages: How it Works
▪ Setting the Heater Start and Stop Times
▪ 0-10V Heater Output: How it Works
▪ Brooder Heater: How it Works
▪ Brooder Curve: How it Works
▪ Setting the Brooder Curve Start and Stop Temperatures
▪ 0-10V Brooder Heater Output: How it Works
▪ Setting the Brooder 0-10V Start and Stop Temperatures
▪ Clock Outputs: How it Works
▪ Setting the Clock Output Start and Stop Temperatures
▪ Setting the 0-10V Outputs
Enabling the Misting Output
What You Should Know
The controller can control one misting output. To operate the misting output, the controller refers to the
average reading of the temperature probes assigned to the output.
When the temperature reaches the start temperature of the output, mist units are activated and run in
timer mode according to their minimum timer (Min On Time & Min Off Time). Then, as the temperature
rises, a gradual transition is made from the minimum timer towards the maximum timer (Max On Time).
The second mist timer is fully used when the temperature reaches the Maximum Temperature parameter
setting. The misting output is disabled when the temperature falls below a user-defined value. It can also
stop when humidity levels are too high.
1. Using the menu select arrow keys, navigate to Start / Stop Temps→Cooling .
This parameter is accessible if the cooling output is enabled.
2. Set the following parameters:
On Temp. / Off Temp Select the temperature at which the cooling output starts
and stops.
Min/Max On Time Set the minimum and maximum On Time of the cooling
timer.
Max Temperature
Set the temperature at which the cooling output uses its
maximum timer settings. The maximum temperature must
be at least 0.5°F (0.3°C) greater than the On temperature.
890-00081 Expert VT-110 53