AP Expert VT-110, Руководство пользователя

Страница: 55 / 84

Chapter 14: Outputs
Setting the Heater Start and Stop Times
1. Using the menu select arrow keys, navigate to Start / Stop Temps→Heaters .
2. Set the following parameters:
On temperature Set the temperature below which each heating stage starts. If the Hi fire option
is used, set this temperature separately for both steps of the heating stage.
Off temperature Set the temperature at which each heating stage stops. Note that the Off Tem-
perature of a heating stage must be at least 0.5°F (0.3°C) higher that its On
Temperature. If the Hi fire option is used, set this temperature separately for
both steps of the heating stage.
0-10V Heater Output: How it Works
The controller has two 0-10V outputs that can either be used to control heaters or fans. To operate these
outputs, the controller refers to the average temperature reading of their assigned temperature probes.
The 0-10V heater start at their minimum intensity when the temperature falls below the start temperature
of the output. The intensity of the heater increases as the temperature decreases; the maximum intensity
is reached when the temperature falls below the Max. Temperature parameter setting.
890-00081 Expert VT-110 55