Overview
1-12
For Internal Modem Card (AOpen FM56-P):
1. Go into the BIOS Setup, select Power Management and
à
0V Wake On
Modem. Select “Enabled.”
2. Install your application, put into Windows 95 StartUp.
3. Turn the system power off by soft power switch.
4. Connect the 4-pin Wake On Modem cable from FM56-P RING connector to
the MX6B EZ
WOM
connector.
5. Connect your telephone line to the FM56-P modem. You are now ready to
use Wake On Modem.
For External Box Modem:
1. Go into the BIOS Setup, select Power Management and
à
0V Wake On
Modem. Select “Enabled.”
2. Setup your application, put into Windows 95 StartUp.
3. Turn your system power off by soft power switch.
4. Connect your RS232 modem cable from your external box Modem to
COM1 or COM2.
5. Connect telephone line to external box Modem. Turn on Modem power (you
must keep Modem power always on). You are now ready to use Wake On
Modem.
Tip:
External modem wake up signal is detected through
COM1 or COM2. An internal modem card wake up signal is
detected through a cable from the connector RING (on the
modem card) to WOM (on the mainboard).
Note:
If you use an external modem, the power of the
external modem must be kept on to receive a signal from
the telephone line. An internal modem card has no such
limitation.
