1. JP14 Clear CMOS
Everything you need to boot this
motherboard is included in this
Easy Installation Guide. For more
information, a complete
Online
User's Manual
can be found in the
Bonus Pack CD
. Thanks for the
help of saving our earth.
PART NO: 49.8B803.001
DOC. NO: MX4SGI4DN-EG-E0305A
You can clear CMOS to restore system default setting. To
clear the CMOS, follow the procedure below.
1. Turn off the system and unplug the AC power.
2. Remove ATX power cable from connector PWR2.
3. Locate JP14 and short pins 2-3 for a few seconds.
4. Return JP14 to its normal setting by shorting pin 1 & pin 2.
5. Connect ATX power cable back to connector PWR2.
Tip:
When should I Clear CMOS?
1. Boot fail because of overclocking…
2. Forget password…
3. Troubleshooting…
This Easy Installation Guide x1
80-wire IDE Cable x1
Floppy Disk Drive Cable x1
Serial ATA Cable x1
Registration Card x1
Bonus Pack CD x1
Pin 1
Normal
(default)
Clear CMOS
1
1
2. JP28 Keyboard/Mouse Wake-up Enable/Disable Jumper
This motherboard provides keyboard / mouse wake-up function. You can use JP28 to enable or disable this
function, which could resume your system from suspend mode with keyboard or mouse installed. The factory
default setting is set to “Disable”(1-2), and you may enable this function by setting the jumper to 2-3.
JP28
KB/Mouse Wake-up
Pin 1
Enable
Disable
(Default)
Pin 1
Note:
To ensure JP28 wakeup
function works properly, please go
to BIOS to enable/disable the S3
S4 KB_Mouse Wake Up item
same as the setting onboard.
Otherwise, the JP28 wakeup
function will not act accordingly
when suspend mode is activated.
