DDR266 DDR333 DDR400
CPU FSB 400MHz
V X X
CPU FSB 533MHz
V V X
CPU FSB 800MHz
V V V
8. S/PDIF Connector
9. Front Panel Connector
7. Installing Memory Modules
S/PDIF (Sony/Philips Digital Interface) is a latest audio transfer file format that provides impressive
quality through optical fiber and allows you to enjoy digital audio instead of analog. Normally there
are two S/PDIF outputs as shown, one for RCA connector, the most common one used for consumer
audio products, and the other for optical connector with a even better audio quality. Through a
specific audio cable, you can connect the S/PDIF connector to a S/PDIF audio module bearing
S/PDIF digital output. However, you must have a S/PDIF supported speaker with S/PDIF digital input
to make the most of this function.
6. Connecting Serial ATA Disk
To connect a Serial ATA disk, you have to have a 7-pin serial ATA cable. Connect two ends
of the serial ATA cable to the serial ATA header on the mainboard and the disk. Like every
other traditional disk, you also have to connect a power cable. Please note that it is a
jumper free implement; you don’t need to set jumpers to define a master or slave disk.
When connecting two serial ATA disks, the system will automatically take the one
connected to “Serial ATA 1” header as a master disk.
Attach the power LED, speaker, and reset switch connectors to
the corresponding pins. If you enable “Suspend Mode” item in
BIOS Setup, the ACPI & Power LED will keep flashing while
the system is in suspend mode.
Locate the power switch cable from your ATX housing. It is
2-pin female connector from the housing front panel. Plug this
connector to the soft-power switch connector marked
SPWR
.
Pin1
This motherboard has two 184-pin DDR DIMM sockets that allow you to install 128-bit dual
channel
DDR400
,
DDR333
or
DDR266
memory up to 2GB. Only non-ECC DDR RAM is
supported. Please install suitable modules; otherwise serious damage may occur on
memory sockets or you RAM modules.
Please note that when you install DDR333
memory module and have your CPU FSB set at 800MHz, the memory can only run
with the speed of DDR320. It is limitation of Intel.
For other limitation of CPU types,
please see the table below.
1
5VSB
SPWR
ACPI LED-
GND
ACPILED
NC
ACPI_B
GND
RESET
GND
NC
NC
+5V
IDE LED
IDE LED
+5V
+5V
GND
NC
SPEAKER
1
Speaker
IDE LED
SPWR
ACPI & PWR
LED
Reset
ACPILED
(Blue)
Serial ATA header to
connect Serial ATA disk
Note: Please note that
only under Windows XP
and Windows.Net
environment can you
install the total of 2
Parallel ATA and 2
Serial ATA disks.
S/PDIF Module
(User Upgrade Optional)
S/PDIF IN
S/PDIF OUT
S/PDIF OUT
S/PDIF
S/PDIF IN
(Optical)
DIMM1
DIMM2
