1
Pin 1
Secondary
Slave (4th)
Primary
Master (1st)
Primary
Slave (2nd)
Secondary
Master (3rd)
7. Install DIMM Modules
6. JP23 FSB/PCI Clock Ratio
8. Connecting IDE and Floppy Cables
9. Connecting Front Panel Cable
This jumper is used to specify the relationship of PCI and FSB clock. Generally
speaking, if you are not overclockers, we recommend you to set at the default setting.
This motherboard has two 168-pin DIMM sockets that allow you to install PC100 or
PC133 memory up to 512MB. The MX3W-E2 supports both Non-ECC and ECC Register
SDRAM Modules.
Connect 34-pin floppy cable and 40-pin IDE cable to floppy connector FDD and IDE
connector. The
blue connector
is IDE1 for clear identification. Be careful of the pin1
orientation. Wrong orientation may cause system damage.
Warning:
Higher CPU FSB frequency may be
able to increase CPU speed, but you may damage
the CPU or reduce the CPU lifecycle.
Speaker
IDE LED
+
+
+
SPWR
+
+ ACPI & PWR
LED
Reset
1
5VSB
PWRBTI
ACPI LED -
GND
ACPI LED
NC
NC
GND
RESET
GND
GND
LEDPWR
+5V
IDE LED
IDE LED
+5V
+5V
GND
NC
SPEAKER
Attach the power LED, speaker, and reset switch connectors
to the corresponding pins. If you enable “Suspend Mode” item
in BIOS Setup, the ACPI & Power LED will keep flashing while
the system is in suspend mode.
Locate the power switch cable from your ATX housing. It is
2-pin female connector from the housing front panel. Plug this
connector to the soft-power switch connector marked
SPWR
.
Auto (Default)
FSB=122~160MHz
FSB=95~166MHz
FSB=66.6~80MHz
1
JP23
ATA 33/66/100 IDE
Connector
FDD Connector
Pin 1
JP23 FSB Select
Jumper
1
1
1
DIMM1
DIMM2
Pin 1
KEYLOCK -
