13. Support 1Gbps LAN onboard
11. PC99 Color Coded Back Panel
12. ZCR (Zero Channel RAID) Function
The onboard I/O devices are PS/2 Keyboard, PS/2 Mouse, COM1, VGA, Printer and
USB1.1. The view angle of drawing shown here is from the back panel of the housing.
PS/2 Keyboard:
For standard keyboard, which is using a PS/2 plug.
PS/2 Mouse:
For PC-Mouse, which is using a PS/2 plug.
USB Port:
Available for connecting USB devices.
Parallel Port:
To connect with SPP/ECP/EPP printer.
COM1 To connect with pointing devices, modem or others serial devices.
VGA Connector: To connect with PC monitor.
1GbE Ethernet Port: To connect RJ-45 Ethernet Cable.
RJ45 100/10M Port: To connect RJ-45 Ethernet Cable.
SPP/EPP/ECP Parallel Port
VGA Port
PS/2 Keyboard
Connector
USB1.1
Port
1 GbE
Ethernet
Port
COM 1 Port
A ZCR card is a PCI card that allows a RAID card to use the onboard SCSI chip, thus
lowering cost of RAID solution.
A "Zero-channel" RAID adapter is a PCI RAID
controller that doesn't have any SCSI channels on board. Instead, it is designed to
use the on-board SCSI channels of the motherboard to implement a cost-effective
Hardware RAID solution. Please be informed that only the first PCI slot supports
ZCR function. (AXPS Plus-U only)
The Intel 82545EM integrates Intel’s fourth-generation Gigabit MAC design with fully
integrated, physical-layer circuitry to provide a standard IEEE 802.3 Ethernet interface for
1000BASE-T and 100BASE-TX applications. The left green LED indicates the link mode, it
lights when linking to network and blinking when data transferring is in 10/100Mbps. The
right green LED indicates the transfer mode, and it lights when linking to network and
blinking when data transferring is in 1Gbps/100Mbps.
100Mb LED
Link/Green Act/Flash
Green/1Gb
Link/Green Act/Flash
1Gb Ethernet Port
RJ45
100/10M
Port
1 GbE
Ethernet
Port
PS/2 Mouse
Connector
10Mb LED
Link/Green Act/Flash
100Mb LED
Link/Green Act/Flash
100/10Mb Ethernet Port
14. Chassis Instruction Connector
The “CASE OPEN” header provides chassis intrusion-monitoring function. Please connect
this header to a sensor somewhere on the chassis. So, whenever the sensor is triggered by
lights or the opening of the chassis, the system will send out beep sound to inform you.
Please be informed that this useful function only applies to advanced chassis, you may
purchase an extra sensor, attach it on your chassis, and make a good use of this function.
Chassis Instruction
Connector
(Default Pin2,3)
PIN1
