Pin 1
Primary
Slave (2nd)
Primary
Master (1st)
Secondary
Master (3rd)
Secondary
Slave (4th)
8. Connecting IDE and Floppy Cables
Connect 34-pin floppy cable and 40-pin, 80-wire IDE cable to floppy connector FDD and
IDE connector. Be careful of the pin1 orientation. Wrong orientation may cause system
damage.
ATA 33/66/100
IDE Connector
FDD Connector
IDE 1 (Primary)
IDE 2 (Secondary)
This motherboard provides Eight USB 2.0 connectors. Compared to traditional USB 1.0/1.1
with the speed of 12Mbps, USB 2.0 has a fancy speed up to 480Mbps, which is 40 times
faster than the traditional one.
USB 2.0 Connector
Pin 1
9. Support Eight USB 2.0 Connectors
6. Serial ATA Supported
This motherboard comes with integrated Serial ATA controller in chip, aiming to provide you
an even faster transfer rate of 150 Mbytes/second. The traditional parallel ATA specification
has defined the standard storage interface for PCs with its original speed of just 3
Mbytes/second since the protocol was introduced in the 1980s. And the latest generation of
the interface, Ultra ATA-133, has been developed further with a burst data transfer rate of
133 Mbytes/second. Please be noted that Hot-Plug in is not allowed.
7. Connecting Serial ATA Disk
To connect a Serial ATA disk, you have to have a 7-pin serial ATA cable. Connect two ends
of the serial ATA cable to the serial ATA header on the motherboard and the disk. Like every
other traditional disk, you also have to connect a power cable. Please be noted that it is a
jumper free implement; you don’t need to set jumpers to define a master or slave disk.
When serial ATA hard disks are installed on serial ATA ports, the one connected on Port
0(SATA 1) will be set as the first boot device automatically.
Serial ATA cable
Serial ATA Ports
+5V
SBD7-
SBD7+
GND
NC
+5V
SBD6-
SBD6+
GND
KEY
USB 2.0 Connector
1
Pin 1
Port 1
Port 0
