8. S/PDIF Connector
9. JP28 Keyboard/Mouse Wakeup Select Jumper
7. Super 5.1 Channel Audio Effect
This motherboard comes with an ALC650E Codec which supports high quality of 5.1 Channel audio
effect, bringing you a brand new audio experience. On the strength of the innovative design of
ALC650E, you're able to use standard line-jacks for surround audio output without connecting any
external module. To apply this function, you have to install the audio driver in the Bonus Pack CD as
well as an audio application supporting 5.1 Channel. Picture bellow represents the standard location
of all speakers in 5.1 Channel sound track. Please connect the plug of your front speakers to the
green “Speaker out” port, rear speakers’ plug to the blue “Line in” port and both of the center and
subwoofer speakers to the red “MIC in” port.
S/PDIF (Sony/Philips Digital Interface) is a latest audio transfer file format that provides impressive
quality through optical fiber and allows you to enjoy digital audio instead of analog. Normally there
are two S/PDIF outputs and two inputs on a S/PDIF module as shown below. Through a specific
audio cable, you can connect the S/PDIF connector to a S/PDIF audio module bearing S/PDIF
outputs and inputs. The two outputs are respectively for RCA connector, the most common one used
for consumer audio products, and for optical connector with an even better audio quality. Same as
outputs, you can also connect RCA or optical audio products to input connectors on the module and
have the voice or music come out from your computer. However, you must have a S/PDIF supported
speaker/amplifier/decoder with S/PDIF digital input/output to connect to the S/PDIF digital
input/output to make the most out of this function.
This motherboard provides keyboard / mouse wake-up function. You can use JP28 to
enable or disable this function, which could resume your system from suspend mode with
keyboard or mouse. The factory default setting is set to “Disable”(1-2), and you may
enable this function by setting the jumper to 2-3.
6. Support 2
nd
and 3
rd
USB2.0 Ports
This motherboard provides six USB2.0 ports to connect USB devices such as mouse,
keyboard, modem, printer, etc. There are two connectors on the PC99 back panel. You
can use proper cables to connect USB devices from PC99 back panel or connect USB2
and USB3 headers to the front panel of chassis.
Enable
Disable
(Default)
1
1
USB2 and USB3 Connectors
Pin 1
Pin 1
USBPWR0
USB_FP_P0-
US
GND
KEY
USBPWR0
USB_FP_P1-
US
GND
USB_FP_OC0
1 2
JP28
KB/Mouse Wake-up
Pin1
5
1
+5V
NC
SPDIFOUT
GND
SPDIFIN
S/PDIF Cable
S/PDIF IN (RCA)
S/PDIF OUT (RCA)
S/PDIF IN (Optical)
S/PDIF OUT (Optical)
