1.
Pull up the CPU socket lever and up to
90-degree angle.
2.
Locate Pin 1 in the socket and look for
a (golden) cut edge on the CPU upper
interface.
Match Pin 1 and cut edge.
Then insert the CPU into the socket.
3.
Press down the CPU socket lever and
finish CPU installation.
Plug in the CPU fan cable to the 3-pin
CPU FAN
connector. If you have chassis fan, you
can also plug it on
System FAN
(FAN2)
or
AUX FAN
(FAN3)
connector.
This motherboard comes with a 20-pin ATX power connector and an extra 4-pin connector
as shown below. Make sure you plug in the right direction. We strongly recommend you to
insert the 4-pin connector before connecting the 20-pin connector.
CPU Ratio
8x, 9x, 10x… 21x, 22x, 23x, 24x
CPU FSB (By manual)
100 ~ 200MHz
CPU FSB (By BIOS table)
100, 105, 108, 114, 120 and 123MHz.
CPU
CPU Core
Frequency
FSB
Clock
System
Bus
Ratio
Pentium 4 1.3G
1300MHz
100MHz
400MHz
13x
Pentium 4 1.4G
1400MHz
100MHz
400MHz
14x
Pentium 4 1.5G
1500MHz
100MHz
400MHz
15x
Pentium 4 1.6G
1600MHz
100MHz
400MHz
16x
Pentium 4 1.7G
1700MHz
100MHz
400MHz
17x
Pentium 4 1.8G
1800MHz
100MHz
400MHz
18x
Pentium 4 1.9G
1900MHz
100MHz
400MHz
19x
Pentium 4 2G
2000MHz
100MHz
400MHz
20x
Pentium 4 2.2G
2200MHz
100MHz
400MHz
22x
Pentium 4 2.4G
2400MHz
100MHz
400MHz
24x
5. Setting CPU Voltage & Frequency
Setting CPU Core Voltage
This motherboard supports CPU VID function. The CPU core voltage will be automatically
detected.
Setting CPU Frequency
This motherboard is CPU jumper-less design, you can set CPU frequency through the
BIOS setup, and no jumpers or switches are needed. The default setting is "1MHz
stepping mode", which you can change to "table select mode" by enabling the "Spread
Spectrum" in the bios. so that you can adjust the FSB from "CPU Host/PCI/3V66 Clock"
for overclocking.
3. Installing Processor
Note:
If you do not match the CPU
socket Pin 1 and CPU cut edge well, it
may damage the CPU.
CPU socket lever
CPU Pin 1 and cut edge
Note:
Some CPU fans do not have
sensor pin so they cannot support fan
monitoring.
CPU Fan Connector
GND
SENSOR
+12V
Warning:
VIA Apollo
P4X266 Chipset supports
maximum 400MHz
(100MHz*4) system bus
and 66MHz AGP clock;
higher clock setting may
cause serious system
damage.
4. Installing CPU & System Fan
6. Connecting ATX Power Connector
FAN3 Connector
This socket supports Micro-FC-PGA2 package CPU, which is the latest CPU package
developed by Intel. Other forms of CPU package are impossible to be fitted in.
Ground
12V
12V
Ground
Pin1
FAN2 Connector
COM
COM
-5V
+5V
+5V
+12V
5VSB
PO-OK
COM
+5V
COM
PS-ON
COM
-12V
+3.3V
+3.3V
+3.3V
COM
+5V
COM
GND
+12V
SENSOR
