1. JP14 Clear CMOS
2. JP28 Keyboard/Mouse Wakeup Jumper
Everything you need to boot this
motherboard is included in this
Easy Installation Guide. For more
information, a complete
Online
User's Manual
can be found in the
Bonus Pack CD
. Thanks for the
help of saving our earth.
PART NO: 49.8A401.E01
DOC. NO: AX45F4DMAX-EG-E0310B
Easy Installation Guide x 1
User Manual x 1
40-Wire IDE Cable x 1 (only for AX45F-4D Max)
80-Wire IDE Cable x 1
Floppy Drive Cable x 1
Serial ATA Cable x 1
Serial ATA Power Cable x 1
USB 2.0 Cable x 1 (only for AX45F-4D Max)
S/PDIF Cable x 1 (only for AX45F-4D Max)
Bonus Pack CD x 1
SiS 964 Serial ATA RAID Driver Diskette x 1
Promise Serial ATA Driver Diskette x 1
(only for AX45F-4D Max)
Norton Anti-Virus CD x 1
I/O Shield x 1
This motherboard provides keyboard / mouse wake-up function. You can use JP28 to enable or disable
this function, which could resume your system from suspend mode with keyboard or mouse. The factory
default setting is “Disable” (1-2), and you may enable this function by setting the jumper to 2-3.
You can clear CMOS to restore system default setting. To
clear the CMOS, follow the procedure below.
1. Turn off the system and unplug the AC power.
2. Remove ATX power cable from connector PWR2.
3. Locate JP14 and short pins 2-3 for a few seconds.
4. Return JP14 to its normal setting by shorting pin 1 & pin 2.
5. Connect ATX power cable back to connector PWR2.
Tip:
When should I Clear CMOS?
1. Boot fails because of overclocking…
2. Forget password…
3. Troubleshooting…
Pin 1
Pin 1
Disable
(Default)
1
1
Enable
Normal
(default)
1
Clear CMOS
1
