1. JP14 Clear CMOS
Everything you need to boot this
motherboard is included in this
Easy Installation Guide. For more
information, a complete
Online
User's Manual
can be found in the
Bonus Pack CD
. Thanks for the
help of saving our earth.
PART NO: 49.8AN01.E02 DOC. NO: AK89MAX-EG-E0401C
This Easy Installation Guide x 1
Enhanced Full Pictured Manual x 1
EzRestore Guide x 1
80-Wire IDE Cable x 1
Floppy Drive Cable x 1
Bonus Pack CD x 1
I/O Shield x 1
Norton Anti-Virus CD x 1
Serial ATA Cable x 1 (for AK89 Max only)
Serial ATA Power Cable x 1 (for AK89 Max only)
40-wire IDE Cable x 1 (for AK89 Max only)
Silicon Image Serial ATA Driver Diskette x 1 (for AK89 Max only)
IEEE 1394 Cable x 1 (for AK89 Max only)
USB2.0 + Game Port Cable x 1 (for AK89 Max only)
S/PDIF Cable x 1 (for AK89 Max only)
You can clear CMOS to restore system default setting. To
clear the CMOS, follow the procedure below.
1. Turn off the system and unplug the AC power.
2. Remove ATX power cable from connector PWR2.
3. Locate JP14 and short pins 2-3 for a few seconds.
4. Return JP14 to its normal setting by shorting pin 1 & pin 2.
5. Connect ATX power cable back to connector PWR2.
Tip: When should I Clear CMOS?
1. Boot fails because of overclocking…
2. Forget password…
3. Troubleshooting…
Pin 1
2. JP28 Keyboard/Mouse Wake-up Enable/Disable Jumper
This motherboard provides keyboard / mouse wake-up function. You can use JP28 to enable or disable this
function, which could resume your system from suspend mode with keyboard or mouse installed. The
factory default setting is set to “Disable” (1-2), and you may enable this function by setting the jumper to 2-3.
Pin 1
1
Normal
(default)
1
Clear CMOS
Enable
Disable
(Default)
1 1
