8. IEEE 1394 Connectors
6. Memory & AGP Voltage Adjustment
This motherboard provides six USB 2.0 ports to connect USB devices, such as mouse,
keyboard, modem, printer, etc. There are four ports on the back panel. You can use proper
cables to connect the Front USB connector to USB modules or front panel of chassis.
7. Support USB 2.0 Connector
9. TV Output Connector
With our considerate design, you can adjust memory and AGP voltage in BIOS. The
memory voltage range is from 2.5V to 2.8V and the AGP voltage is from 1.5V to 1.65V.
With IEEE1394 MAC Embedded in nForce2-GT/ST (with AGERE FW802A), the IEEE
1394 provides data transfer rate up to 400Mb/s, and USB just has 12Mbps. Hence, the
IEEE 1394 interface can connect with the devices that need high data transferring
performance, such as digital camera, scanner or others IEEE 1394 devices. Please use
the proper cable to connect with devices.
TPB+
Pin 1
Pin 1
Composite Video
Key
NC
1
2
USB 2.0 Connector
GND
SBD3-
SBD2-
SBD2+
SBD3+
GND
Key
GND
Chroma
Luma
GND
6
5
2
1
+12V(fused)
GND
TPB-
GND
SHIELD GND
-12V(fused)
TPA-
TPA+
1
2
Note:
It is risky to adjust those voltages. Please
make sure your Memory and AGP Card support
those new voltages before you doing that.
(User Upgrade Optional)
Pin 1
AV-Terminal
S-Terminal
This motherboard comes with a TV Output connector which allows you to accept digital
graphic input signal, and encodes, and transmit data through DVI or TV Output. Both NTSC
and PAL TV formats are supported for this function. You may just install a TV Output module
(as shown) to your back panel, connect S-Terminal or AV-terminal to your TV, then use it as
your another monitor.
Warning:
Please be noted that
Hot-Plug in is not allowed on
IEEE 1394 header, because it will
burn the IC of the controller and
damage the motherboard.
