+5VSB
NC
S/PDIFOUT
GND
S/PDIFIN
1
1. JP14 Clear CMOS
Everything you need to boot this
motherboard is included in this
Easy Installation Guide. For more
information, a complete
Online
User's Manual
can be found in the
Bonus Pack CD Disc
. Thanks for
the help of saving our earth.
PART NO: 49.89X02.011
DOC. NO: AK75P-EG-E0204A
You can clear CMOS to restore system default setting. To
clear the CMOS, follow the procedure below.
1. Turn off the system and unplug the AC power.
2. Remove ATX power cable from connector PWR2.
3. Locate JP14 and short pins 2-3 for a few seconds.
4. Return JP14 to its normal setting by shorting pin 1 & pin 2.
5. Connect ATX power cable back to connector PWR2.
Tip: When should I Clear CMOS?
1. Boot fail because of overclocking…
2. Forget password…
3. Troubleshooting…
This Motherboard x1
This Easy Installation Guide x1
80-wire IDE Cable x1
Floppy Disk Drive Cable x1
Bonus Pack CD x1
NORTON AntiVirus CD x1
S/PDIF Module x1 (Optional)
IEEE 1394 Cable x1
Pin 1
Normal Operation
(default)
Clear CMOS
1
1
2. S/PDIF (Sony/Philips Digital Interface) Connector
S/PDIF (Sony/Philips Digital Interface) is a newest audio transfer file format, which provides impressive
quality through optical fiber and allows you to enjoy digital audio instead of analog audio. Normally there are
two S/PDIF outputs as shown, one for RCA connector, the most common one used for consumer audio
products, and the other for optical connector with better audio quality. Through a specific audio cable, you
can connect the S/PDIF connector to other end of the S/PDIF audio module, which bears S/PDIF digital
output. However, you must have a S/PDIF supported speaker with S/PDIF digital input to connect to the
S/PDIF digital output to make the most out of this function.
S/PDIF Module
(Optional)
Connecting to
RCA Cable
Connecting to
Optical Cable
Audio
cable
Pin 1
