22
4.6.8. Device Management
1.
Key Lock (default password is 0000, super
password is 6098, super password is for
logging in and changing password if you
forget password.)
2.
Change password (the new password
comprises numerals only and does not
support letters. To exit from the virtual
keyboard, press the Back button and
move the remote control downward and
then rightward to select OK)
Unlocking mode:
a. Long press the menu button for 5s or
longer, a temporary unlocking prompt will
pop up.
b. A password box will pop up only when
selecting Turn off the lock in Device
Management.
3.
HDMI version (1.4 or 2.0 may be selected
under HDMI or OPS signal only, and it is
recommended that 1.4 be first selected
under OPS signal)
4.
HDMI failover
When the device is powered on, if 2 HDMI
interfaces both have connecting signal,
unplug either interface, and the signal will
automatically switch to the other interface.
5.
Quick boot
When the device is powered on, after
PD is shut down via the remote control,
the last signal will be directly displayed
upon re-boot. The process of displaying
boot logo and rebooting to home page
is omitted.This is the so-called fake shut
down, which has a relatively high power
consumption but shorter boot time.
6.
Wakeup
Wake on LAN: Only wakeup the display
whose wired networks are in the same
network segment is currently supported.
It's difference with serial-port wakeup of
UART should be noted. WOL is connected
to network ports, while UART, a type of
RS232, is connected to RS232 ports.
Signal wakeup: If signal wakeup is
selected, upon receipt of the signal, the
device will automatically boot to such
signal.
UART wakeup: After UART wakeup
function is selected, RS232 may give
command A5 to wake up the PD.
7.
Boot mode
Boot: The device will automatically boot
whenever it is powered on.
Standby: The device will not boot each
time it is powered on, unless the power
button on the remote control is pressed.
Last state: The boot state is recorded. If
the device is shut down via remote control
last time, the device is now powered off
and then powered on and booted. The
standby state will be recorded, and the
power button on the remote control has to
be pressed. If the device is now running,
and if the device is now powered off and
then powered on, the device will boot
automatically and the remote control need
not be pressed again.
