YAG Pulse Laser Power Supply For Welding System
150W/300W/600W Operation Manual
Shenzhen Anzhong Power Co., Ltd http://www.szazdq.com
- 13 -
6.3.1 “Operation”Introduction
Red light,Step key, One-Key Operate and
光闸
control.
6.3.2 “Process Set”Introduction
Feedback Mode:
Energy feedbac and current feedback.
Conmode(Control Mode)
：
Internal control and external control can be chose.
Set Energy
：
In the energy mode,according to the setting parameters to calculate the setting
energy;It will dispaly “0”, under the current mode.
Peak input:
In the current mode, enter the maximum units for 50w as 250A, the minimum is 20A.
In the energy mode, enter the maximum units for 50w as 7.5kw, the minimum is 0.5kw.
Proportion:
Input proportion is 0-100%
；
Frequency:
Laser output frequency is 1-100Hz
；
Hit Num:
Laser output times. When the num is “0”, press the laser key, the laser will output all the
time. When the num is 1-60000, the laser will stop at the num of your set.
Max Energy & Min Energy:
It is the limit of the energy output. When the energy over the limited,
you will see the prompt.
Schedule Mode:
0-31 modes for setting and to corresponding different peak and input percent,
power, laser output frequency and times, Max & Min energy and waveform.
Waveform Setting:
24 waveforms can be set. You can press the Page Up/Down to viewing/clearing
the waveform. Remember press “Save set” to save the waveform what you set, and you can check it