[Transmission line connection]
[Fiber connection]
(Connection example using link connector)
To LP4-WW-10P crimped
transmission line link connector
■
Link connector pin layout
1
2
3
4
DN
DP
0V
24V
Black
Red
White
Green
Pin number Details Line color
FK4-125-100
LP4-WR-10P
Master unit
To LP4-WW-10P crimped
transmission line link connector
FK4-125-100
LP4-WR-10P
Master unit
DP, DN
Local power supply
24V, 0V
[Base unit
transmission line color]
DP
DN
Red
Black
Line color
Details
24V
0V
Green
White
: Transmission line (+)
: Transmission line (-)
: Unit drive power supply (+)
: Unit drive power supply (-)
DP
DN
: Red
: Black
24V
0V
: Green
: White
[Base unit
transmission line color]
■
If mounting through an attachment: Fiber diameter
φ
1.0
■
If mounting directly: Fiber diameter
φ
2.2
■
Cutting of fiber
DP, DN
DP, DN
24V, 0V
■
Power supply to the entire system
■
Local power supply
Purchase the Omron thin fiber attachment E39-F9 separately.
Knob
Fiber port
0.5mm
Fiber cutter
B289-FC *
φ
1.0
Use with attachment (E39-F9)
φ
2.2
Direct
Fiber diameter (mm)
Installation method
■
Included wire details
-L*F1011 6/11-
Connect the transmission line of the base unit to the transmission line
from the master unit.
This terminal is a four-wire (isolated) type that is used by connecting to
DP, DN, 24V, and 0V.
The LP connector (link connector) is a
mixed-contact type connector.
You can link connectors of the same
type to one another to easily perform
"connections" or "branching."
Press down the knob for the fiber port on the amplifier side, fully
insert the fiber into the fiber port, then return the knob upward.
Press down the knob for the fiber port on the amplifier side, fully
insert the fiber into the fiber port, then return the knob upward.
Cut the fiber using the fiber cutter included with the fiber head.
When doing so, pass the fiber through a hole suitable for the fiber
diameter and cut at a right angle.
Do not use a hole that has already been used again.
* One fiber cutter (B289-FC) is included with each AnyWireASLINK fiber head
(AFT-4, AFT-1, AFT-2, AFT-1-1).
Attach to the amplifier with the tip of
the fiber sticking out approx. 0.5mm
beyond the tip of the attachment.
CAUTION
！
When reusing a fiber that has already been mounted,
cut the tip of the fiber again.
Failure to do so may lower the amount of light emitted
and received.
