[Installation]
[Expansion]
[Removal]
[Installation Location]
D
A
A
Upper side
Upper side
D
B
G
Base Extension
LA-F1011 can be expanded by up to 31 LB-F1011 units.
The specifications for the LA-F1011 and LB-F1011 are as follows.
Remove the connector cover.
(Do not lose the cover.)
[Precautions when Using]
Extension
Expansion connector
Base
LINK
IN
ALM
LINK
IN
ALM
C
A
24V-0V
LA-F1011
LB-F1011
DP-DN
25mA
1.9mA
■
Consumption current
Common
LA-F1011
LB-F1011
Common
One-point
One-point
■
Number of occupied points
Up to 32 units
-L*F1011 5/11-
The installation and removal methods are the same for both the base
unit and the extension unit.
The extension unit can be installed as an expansion on the base unit.
Remove the connector cover on the base unit and connect the
extension unit to the built-in expansion connector.
A block with the LA-F1011 expanded by 31 LB-F1011 units occupies
32 input points.
Also, the DP-DN consumption current is 60.8mA.
If fiber input with 32 optical axes or more is required, install a separate
block.
If only the LA-F1011 and LB-F1011 are connected, a single system
can support up to 128 units.
Hook movable latch A onto the DIN rail.
Push down on fixed latch D on the opposite side until you hear a click.
Push this product in direction B, removing fixed latch D from the DIN rail.
Lift up straight in direction G, lifting and removing the product.
- Location where this product is not directly subject to vibration or shock
- Location where this product is not directly exposed to dust
- Location where this product is not directly exposed to a conductor, such as
waste metal or sputter
- Location without condensation
- Location where the atmosphere is free of corrosive gas, flammable gas, and
sulfur
- Location far from high-voltage or high-current cables
- Location far from cables and controllers that generate servo, inverter, or other
high-frequency noise
If connecting this unit to a transmission line or expanding the base unit with an
extension unit, do so with supply of the transmission signal stopped.
Performing connections while wires are live may cause the unit to detect
chattering as an error upon connection and stop.
If installing vertically, bring the
movable latch below the DIN rail.
