PA-U1D-C-FA User Manual
ACT-PA-U1D-USR-DOC-V2.2, 09/25/2019
Page 18 of 22
including IP, Mask, and Gateway. The AGC screen is used to turn the PA AGC On/Off and to change the
target AGC output power level.
Network Screen
: The User can check and set all the Controller network information in this screen.
Re-Default: Reset Default settings - This button is used to set all the network settings to the
default values, as shown below:
IP:
192.168.1.210
MASK:
255.255.255.0
GateWay:
192.168.1.1
Set: There is a Set button for each bar on this screen. Pressing the Set button will lead to the
corresponding configuration screen of IP or Mask or GateWay accordingly. Using the IP setting
as an example, Press any part of the white bar on the IP Setting Screen and the keyboard (shown
below) will be enabled, turning from grey to yellow. The user can only set 3-digits of one bar at a
time. When the configuration is finished, press OK to confirm. If the keyboard is enabled by
