User Manual of WP-67 Water-proof Two-way Radio
- 6 -
■Basic operations
◆
Monitoring function
In standby mode, press [MONI] key to start monitoring. When squelch circuit is shut off, you will hear the background noise (the prompt tone
sounds once); release the same key to stop monitoring, then you will not hear the background noise.
If it is needed to check whether channel interference exists, you can press this key and rotate the volume control knob, then you will hear
the background noise or interference noise.
■Scanning function
Your two-way radio finds out whether there is voice activity in current channel/contacts group by scanning the channel/contacts group sequence
in the list. Your two-way radio can support up to 16 scanning list. You can add or delete channels by editing the scanning lists with frequency
writing software.
◆
Start and stop scanning
Execute the operation steps below:
1) Start scanning by pressing [*SCAN] key.
·or: When scanning, your two-way radio stops in the channel/contacts group where activity is detected. The two-way radio stops in the channel
for the preset time which is called "idle time",indicator keeping green. You can press the [PTT] key and then speak to the microphone clearly.
2) If you fail to make a response within the idle time, the two-way radio shall go back and scan other channels/contacts groups.
3) You can stop the scanning by pressing [*SCAN] key during scanning.
◆
Scan temporary delete
1)When start Scan temporary delete,the set to [*Scan temporary delete] channel will not be scanned
2)If want to restart scan, pressing [*Scan temporary delete] key.
◆
Power setting
Select power (HIGH/LOW) by pressing [*High/Low power switch] key.
◆
Talk around
When using the talk around, the frequency of the interphone becomes the same of the receiving frequency; the transmitting signaling also turns
to be the same as the receiving signal.
◆
reverse frequency
Reverse frequency function reverse TX frequency and RX frequency
◆
VOX
1
）
After this function is activated, if the speech volume of the user reaches the level set for the two-way radio, the two-way radio can activate
transmitting operation via voice without the [
PTT
] key being pressed. The function above may be activated in certain workplaces where the
user's hands are too occupied to press [
PTT
] key. Execute the operation steps below:
voice control sensitivity (selection range is 1~10; the greater the value is, the higher the sensitivity is) .
2) Return to the previous menu.
▲After the VOX function is activated, the voice can be transmitted by speaking to the microphone; the transmitting shall be stopped by stopping
speaking. You can select VOX sensitivity level according to the quiet degree of service environment; in the environment where there are too
