Antunes RS-1000 INTL, Руководство пользователя

Страница: 3 / 21

®
P/N 1011504 Rev B 11/18
3
Safety Information
Operation
Use the following guidelines for safe
operation of the steamer.
y
Read all instructions before
using equipment.
y
For your safety, the equipment is
furnished with a properly grounded
cord connector. Do not attempt to
defeat the grounded connector.
y
Install or locate the equipment only
for its intended use as described in
this manual. Do not use corrosive
chemicals in this equipment.
y
Do not operate this equipment if
it has a damaged cord or plug, if
it is not working properly, or if it
has been damaged or dropped.
y
Do not block or cover any
openings on the steamer.
y
Do not immerse cord
or plug in water.
y
Keep cord away from
heated surfaces.
y
Do not use an extension
cord with this device.
y
Do not allow cord to hang over
edge of table or counter.
NOTICE
: Turning off the power switch
does NOT turn off all power to
the steamer.
y
The equipment should be
grounded according to local
electrical codes to prevent the
possibility of electrical shock. It
requires a grounded receptacle
with separate electrical lines,
protected by fuses or circuit
breaker of the proper rating.
y
All electrical connections
must be in accordance with
local electrical codes and any
other applicable codes.
Backflow Protection
The Rapid Steamer RS-1000 must
be installed with adequate backflow
protection to comply with applicable
federal, state, and local codes.
Maintenance
y
Do not use abrasive materials;
they can damage the steamer’s
stainless steel finish.
y
Do not use corrosive chemicals
in this equipment.
y
Chlorides or phosphates in
cleaning agents (e.g., bleach,
sanitizers, degreasers, and
detergents) can permanently
damage stainless steel equipment.
The damage is usually in the form
of discoloration, dulling of the metal
surface finish, pits, voids, holes, or
cracks. This damage is permanent
and is not covered by warranty.
y
Use only chemical cleaners
that are safe for cast aluminum.
Observe all precautions and
warnings on product labels.
y
Always use a soft, damp cloth
for cleaning. Rinse with clear
water and wipe dry. When
required, always rub in the
direction of metal polish lines.
y
Routine cleaning should be
performed daily with soap,
ammonia detergent, and water.
y
Sponge stains and hard water
spots with a 50% vinegar solution.
y
Rub off finger marks and
smears using soap and water.
y
Do not clean the steamer
with a water jet.
Service
y
Inspection, testing, and
repair of electrical equipment
must be performed only by
qualified service personnel.
y
Have the steamer serviced only
by qualified personnel. Contact
Antunes Technical Service
for adjustment or repair.
y
Turn the power off, unplug
the power cord, and allow
steamer to cool to room
temperature before performing
any service or maintenance.
y
If the supply cord is damaged,
it must be replaced by the
manufacturer, its service agent,
or a similarly qualified person in
order to avoid an electrical hazard.