MANUAL EGG COOKER/STEAMER
6
P/N 1010964 Rev. K 01/17
McDonald’s
Unpacking
1. Remove unit and all packing materials from
shipping carton.
NOTE: If any parts are missing or damaged,
contact A.J. Antunes & Co. IMMEDIATELY at
1-877-392-7854 or 630-784-1000.
2. Remove information packet.
3. Remove all packing materials and protective
coverings from the unit.
4. Wipe all surfaces of the unit with a hot damp
cloth.
NOTE: Do NOT use a dripping wet cloth. Wring it
out before use.
5. Clean the Egg Rings, Egg Rack, Top Cover, and
Scrap Pans in hot, soapy water. Rinse in clear
water and allow to air dry.
6. Reassemble the unit.
INSTALLATION
Figure 3. Rotating Top Cover and Egg Rack
Top Cover
Egg
Rack
Universal Top Cover and Egg Rack
The MES-1200 is designed with a Universal Top Cover
and Egg Rack that can lift open from either the left- or
right-hand side depending on restaurant setup. The
Universal Top Cover is pre-assembled at the factory
with the handle on the right side of the assembly.
To rotate the Top Cover and Egg Rack, refer to Figures
1, 2, and 3.
1. Remove Top Cover Handle (A).
2. Remove Cover Plate, screws, & nuts
from reverse side (B)
3. Install Top Cover Handle on reverse side.
4. Install Cover Plate, screws, & nuts on reverse side.
A
B
Figure 1. Rotating Top Cover Handle
1. Remove Egg Rack Handle Mount (A).
2. Install Egg Rack Handle Mount on
reverse side of the Egg Rack (B).
A
B
Figure 2. Rotating Egg Rack Handle
The Top Cover and Egg Rack can be installed on unit
to open from the left or right side.
IMPORTANT
Failure to level the unit may result in unevenly
cooked product.
Leveling the Unit
The MES-1200 must be placed on a level surface. The
unit comes with 4 individually adjustable legs to assist
in leveling. Be sure to place the unit on a sturdy flat sur-
face and adjust the legs as needed to ensure the unit
is level. Turn legs
clockwise to shorten
or
counter-
clockwise to lengthen
.
To verify if the unit is level, use a level (if available).
If a level is not available, open the Top Cover and
Egg Rack and pour a small amount of water directly
onto the cool grill surface. If the unit is level, the water
should pool in the middle and not drain toward a certain
section of the unit. Make adjustments as required.
Turn Leg
Clockwise
to shorten.
Turn Leg
Counter-clockwise
to lengthen.