Antunes, AJ UTX-200, Руководство пользователя

Страница: 14 / 20

Universal ToasTer UTX-200
14
P/N 1010904 Rev. B 03/12
McDonald’s
A.J. Antunes & Co.
dailY: Cleaning the accessories, release
sheet, and vertical Conveyor belt
note: do not wash accessories in the Power
Soak machine.
CleaninG tHe aCCessories and toaster
1. Turn the Power Switch off. The red light on the
switch turns off.
2. The unit enters cool down mode and displays
“OK to Clean” (see display). The fans continue to
run. This cool down mode continues for 45 min-
utes and shuts the unit down automatically when
complete.
note: You do not need to wait for the count down
to complete. Continue with the cleaning steps as
soon as you see “oK to clean.”
3. Wearing heat Resistant Gloves, remove the fol-
lowing items from the unit (refer to Figure 1):
• Breakfast Chute (Rear of unit)
• Bun Feeder (Top of unit)
• Bun Buffer (Front of unit)
• Unit Crumb Tray (Rear of unit)
• Release Sheet Retainer Bar and Release
Sheet (Top of unit)
MaintenanCe
WarninG
the unit will remain hot to the touch while it is
cooling down. Personal injury and burns may
result from touching the unit before it is finished
cooling down. Wear Heat resistant Gloves!
Figure 7. Back Panel Release Latches
SELECT
SELEC
T
LOCKED UNLOCKED
(Horizontal) (Vertical)
release latches (on
botH sides of the rear of
the unit) are locked when
in the horizontal position.
turn both latches to the
vertical position to open
and unlock the Back
Panel
CleaninG tHe release sHeet
1. Remove the Release Sheet from the Release
Sheet Retainer Bar and inspect both sides of the
Release sheet.
note: replace the release sheet if it is overly
worn, creased, or torn.
2. Lay the release sheet on a clean, flat, dry sur-
face. Spray eXCeed Glass and Multi-Purpose
Cleaner (HCs) on a clean, dry towel.
3. Wipe the Release Sheet firmly from top to bottom
over its entire surface.
4. Immediately repeat this procedure with a clean,
dry towel dampened with water.
5. Finally, wipe the entire Release Sheet with a clean
towel dampened with KAYQUAT II™ Sanitizer
solution (HCs) and allow to air dry.
6. Turn the Release Sheet over and repeat Steps 2
through 5 on the reverse side.
CleaninG tHe vertiCal ConveYor belt
1. Facing the rear of the unit, turn the two Back
Panel Release Latches (Figure 7) so they are in
the vertical position and open the Back Panel.
NOTE: Make sure to wear Heat Resistant Neoprene
Gloves.
WarninG
do not wash any of the accessories in a Power
Soak Machine or any other mechanical washer.
damage to the accessories may result. Wash all
accessories by hand in the sink.
4. Set the Release Sheet Retainer Bar and the
Release Sheet aside.
5. Wash the Breakfast Chute, Bun Feeder, Bun
Buffer, and Crumb Tray in the three compartment
sink.
6. Wipe down the outside of the toaster with a clean,
sanitized towel dampened with KaYQUat ii™
Sanitizer Solution (HCS) .