2. Receiver unit (RX)
1. LENGTH: automatic cable detection for adjusting to the lengof the network
cable
2. RJ45 signal input
3. RJ45 indicator led is lit solid when HDMI signal transmission takes place, It
will flash when signal is not being transferred.
4. DV5V power input (OPTIONAL)
5. HDMI signal output
6. IR receiver sensor port
Cable Length Optimizer:
The LENGTH button allows the user to switch between automatic and manual
settings for the cable length. If the cable run is particularly short then the length
feature may be used to optimize the signal for the cable length.
When powered on, the device will use the any settings previously made for cable
length. To set it up for the first time, follow the procedure below:
Power on and then press LENGTH key twice, this enables the cable length
optimizer and the device will now adapt to the cable length.
The following 12 times of pressing, it will entering manual mode in 12 levels to
meet different cable length. After all 12 levels of press, it will entering auto mode
again and into next loop.
