Owner's Manual for Anthro Tablet Charging Carts
3
Loading Devices, Cable Management
In the front User area of the cart
• Check that the vertical spacing of the shelves fits your devices.
To adjust shelf height, use a Phillips screwdriver to loosen (not
remove) the 2 screws that attach the left side of the shelf. Lift
the left side off the screws
and pull the shelf to the left
to free the tabs on the right.
Set aside the shelf. Remove
and reinstall the screws and
shelf at the desired height.
[Image A]
• Check that the horizontal
spacing of the bay dividers
fits your devices and cases.
To move the dividers and
adjust the bay width,
press back on the divider
tab under the shelf that
connects the divider to the
shelf until the divider pops
free. If your fingers don't fit,
try a flat-head screwdriver.
To install the divider, angle the divider into a slot at the back
of the shelf, then tilt the divider into place at the front of the
shelf. [Image B] Number each bay with the provided labels.
• To route the cords, route one
charging cord along the top
of each divider. Make sure
that the cord end that goes
into the device is at the front
of the bay and the power
end goes through the center
panel and into the IT area.
• Leave enough slack in front
(approximately 4.5”; use the
height of the divider as a
measuring stick) so users can
plug in the device without
straining the cord. [Image C]
• Weave the cord around the
short hook at the front of
the divider, then back and
forth through the three long
channels along the top of the
divider, including the center
channel that’s lower than the
others, and finally through
the short hook at the back of
the divider. [Image D and E]
• Feed the rest of the cord
into the IT area. [Image F]
• Slide devices into bays
so the power inlet is
convenient to the front of
the bay.
• Use the adhesive bay label
stickers to number each bay.
In the back IT area of the cart - READ QUICK GUIDE FIRST!
• In the back IT area, USB ports are numbered to correspond
with the bays up front. Route cords from the User area into
the IT area so the cord from each bay reaches its USB port.
• For initial deployment, check the Quick Guide or your own
deployment plan before connecting tablets to the cart.
C
D
E
F
A
B
