A
B
C
D
E
F
G
DISPLAY
O P E R A T I O N
Before plugging in the CD 1, check to see that the unit is
configured for the correct AC line voltage for country of use.
The operating AC line voltage is indicated on the side of the
shipping box. If the CD 1 is set incorrectly for the country in
which it is to be operated, contact the dealer or distributor
in your area. If the unit is configured properly, continue with
operation.
Connect the Detachable Power Cord to the CD 1 chassis
rear (see Figure 6). Plug your CD 1 into the AC power
source. You may now turn on the CD 1.
Note: Never unplug your CD 1 during operation. First
shut off your Power Amplifier, then stop the CD 1 by
depressing the Stop button (D), and remove AC
power by pressing and releasing Power Switch (G).
It is recommended that you shut OFF the main power via the Power
Switch (G) when not listening.
T R O U B L E S H O O T I N G
If at any time the CD 1 fails to work properly, consult this checklist:
1. Check that the AC Detachable Power Cord is plugged into
the CD 1 Detachable Power Cord Socket (H) and is connected
to a live source of AC power. For instance, if using a power bar,
check that the bar is turned on.
2. Ensure that all Input and Output connections are secure for
a proper electrical contact.
3. DISCONNECT THE AC POWER CORD, wait 5 minutes,
remove the chassis covers from the CD 1 and check that:
• A “fast-blo” fuse, with a rating of 1 Amp/250 V (0.5 Amp/250
V for European and Asian versions), is installed on the circuit
board under the soft plastic cover (see figure 2).
• The AC power fuse is intact and has not blown. If the fuse has
blown, the thin metal conductor will have melted and the glass
may appear “smoked”. If the fuse has blown, replace with a
fuse of the same rating (1 Amp/250V fast-blo for 100 to 120 volt
countries and .5 Amp/250V fast-blo for 220 to 240 volt
countries). (See Figure 2.)
NOTE: Under no circumstances should you replace the AC
power fuse with one of a higher current rating! Doing so may
cause damage to the CD 1 and will also void the warranty. In
addition, your continued protection from risk of fire or shock
would be seriously compromised.
• Ensure the tube is plugged firmly into its socket.
4. Be sure the rest of the system is functioning properly (i.e.
preamps, power amplifiers, cables and connections, etc.).
5. With tubes, fuses, covers and power cords in place, check
that the Display is lit. If all of the above troubleshooting steps
have been followed and the Display is not lit, contact your dealer
or distributor for assistance.
Figure 6 - Alignment of the AC power connector and detachable cord.
WARNING-DISCONNECT THE AC
DETACHABLE POWER CORD FROM THE
CD 1 AND WAIT 5 MINUTES BEFORE
REMOVING COVER, TUBES OR FUSE.
DANGER:
INVISIBLE LASER RADIATION
POSSIBLE WHEN THE TOP COVER
IS REMOVED. AVOID DIRECT
EXPOSURE TO THE LASER BEAM.
Figure 3. CD 1 Front