Anthem AVM 40, Руководство по эксплуатации

Страница: 44 / 86

36
3. SETUP MENU
continued …
3.10 TRIGGERS / IR / RS-232
When a trigger output on the AVM 40 is connected to the trigger input of another component, such as a
power amplifier or video projector, the AVM 40 can turn the component on or off according to the trigger’s
Setup. For components that do not use triggers, a triggerable power bar may work (see your dealer).
• Trigger1 and Trigger2: Provide standard trigger output of 12 volts with up to 50 mA of current,
suitable for most amplifiers.
• Trigger3: Provides an output of 12 volts with up to 200 mA of current, suitable for most amplifiers
and depending on requirements, usable with motorized projection equipment.
There is a quarter of a second delay between each trigger to minimize momentary line voltage drops caused
by switching on too many devices at the same time.
All Triggers:
When on ‘Disabled’ all triggers remain off. When on ‘Enabled’ the trigger chart below is used to set
conditions. For custom installations, ‘RS-232 Ctrl’ uses external control over all triggers.
Set Trigger:
Highlighting ‘b. SET TRIGGER 1’ and then pressing SELECT displays this menu – in the example shown,
TRIGGER 1 activates whenever MAIN power is turned on:
Under each of the four Paths, notice that there are dashes (‘–’). After highlighting POWER ON or a Source,
press
SELECT and use the buttons to move from one Path to another, and then to set the trigger to
activate, use the buttons to change the ‘ – ’ to a ‘ * ’ (don’t forget: a. ALL TRIGGERS: ‘Enabled’ in menu 10).
10. TRIGGERS / IR / RS-232
a. ALL TRIGGERS : Disabled
b. SET TRIGGER 1
c. SET TRIGGER 2
d. SET TRIGGER 3
e. SET IR-INPUTS
f. BAUD RATE : 19200
g. FLOW CONTROL : None
h. RS-232 TX STATUS : Off
10b. SET TRIG-1 SOURCES - 50mA
MAIN Z2 Z3 REC
a. POWER ON : * – –
b. CD : – – – –
c. 2-Ch : – – – –
d. 6-Ch : – – – –
e. TAPE : – – – –
f. FM/AM : – – – –
(g-j.) DVD1-4 : – – – –
(k-n.) TV1-4 : – – – –
(o-p.) SAT1-2 : – – – –
q. VCR : – – – –
r. AUX : – – – –