7
MINIMUM HARDWARE RECOMMENDED
Ÿ
16 MHz 386-SX or compatible
Ÿ
28 mSec average access hard disk
Ÿ
1:1 Interleave hard disk controller
Ÿ
Mouse
Ÿ
VGA display
ADAPTER INSTALLATION
Make sure the main power to your computer is OFF. You will need a full-size, 16 bit/AT slot. If you are
unfamiliar with the internal design of your computer see its "Guide to Operations" manual for step by step
installation procedures.
Read
JUMPER SETTINGS
and
for information about configuring the adapter before plugging it into the
slot.
JUMPER SETTINGS
These SX series adapters have four hardware jumpers. They are JP1, JP2, JP3 and JP4, which are
used for multiple board operation. JP1 should be installed for a single board system.
NOTE:
On the SX-7, jumper JP2 serves as the adapter selection jumper. Adapter 1 is at the top, with
adapter 4 at the bottom.
1
2
3
4
PLACE JUMPER HERE IF YOU HAVE ONLY ONE
ADAPTER
I/O ADDRESSES AND INTERRUPTS
The valid I/O addresses for the SX7, SX9, SX11, SX-12a, SX20, SX22, SX23e and SX26 are:
180h, 22h, 280h, 300h, 320h and 380h
The valid interrupts are:
2, 3, 4, 5, 10, 11 and 12