6.
Seal the fiberglass antenna joint against moisture ingress with a sealing tape.
7.
The antenna is designed to mount the antenna on the side of a tower.
8.
The side mounting assembly is designed for mounting the antenna on triangular tower
having round leg of 1.5-2.0 Inches (38-52 mm) in diameter.
9.
Three-crossover plate clamp sets are fixed on each Grounded Support Pipe and Three-
crossover clamp set are fixed on Insulated Support Pipe for attachment of antenna to
the tower.
10.
Install the Collinear Antenna on the side of the tower, by using two Grounded Mounting
Assembly and one Insulated Support Assembly, supplied with the antenna.
11.
The Insulated Mounting Assembly is supplied to hold the antenna from the top. An
insulated crossover clamp set is supplied with the antenna. Fix this insulated crossover
clamp set on the top of fiberglass portion of the collinear antenna.
12.
Take extreme care during Installation that the Collinear Antenna should be minimum 3
FEET away from tower.
13.
When the installation of the antenna has been completed, it is necessary to ensure that
the installation instructions have been followed in all aspects
14.
Connect the antenna feeder cable to the N-Female connector (provided at the bottom)
of the Collinear Antenna and secure it with cable ties.
15.
Seal the connector against moisture ingress with a sealing tape.
16.
Take VSWR reading by using through-line RF Power meter. The VSWR should never
exceed 1:1.5.
17.
Keep the record of VSWR measurements for future reference.
18.
Tighten all nuts and bolts.
